Telecommunication Outlet Specifications

100-ohm UTP Cable

Each four-pair cable shall be terminated in an eight-position modular jack in the work area. The 100-ohm UTP telecommunications outlet shall meet the requirements described in EIA/TIA-570.

150 ohm STP-Cable

The telecommunications connector used for terminating the 150-ohm STP cable shall be that specified by ANSI/IEEE 802.5 for the media interface connector. This connector shall be designed so that like units will mate when oriented 180 degrees with respect to each other.

• Guides

• Lamp Guide: General Information
• Lamp Guide: Fluorescent
• Lamp Guide: HID
• Lamp Guide: Incandescent
• Line Noise
• Power Surges and Spikes
• Brownouts
• Blackouts
• Heat Dissipation in Electrical Enclosures
• Hazardous Location Basics
• Basic Proximity Sensor Operations
• Occupancy Sensor Design Guide
• Occupancy Sensor Application Guide
• Color Application for HID Lamps
• Cutler-Hammer Heater Coil
• General Electric Heater Coil

• Electrical Tables

• Allowable Ampacities Insulated Conductors
• Conduit Fill Table
• NEMA Straight Blade Configs
• NEMA Locking Blade Configs
• Common Conversion Factors
• Derate 3 Conductors in a Raceway
• Direct Current Motor Full Load Current
• Approximate Full Load Amperes
• Full Load Current: Three Phase AC Motors
• Full-Load Current: Single Phase AC Motors
• Specific Resistance
• Temperature Conversion Table
• UL Fuse Classification Chart
• Buck Boost Transformer Full Load Amps

• Calculations

• Ohm's Law
• Electrical Formulas
• Full Load Formula

• Datacomm Tables

• Attenuation for Coaxial and UTP Cables
• Backbone Runs: UTP Cable
• Basic/Channel Link Attenuation
• Basic/Channel Link Next Loss
• Cable Administration
• Category Cables
• Circuit Protection
• Common Ethernet Systems
• Common Types of Cabling
• Computer Circuits
• Copper Wire Limitations
• Digital Patch Cable (DPC) Coding
• 10Base-T Crossover Patch Cord
• 10Base-T Straight Thru Patch Cord
• General Cable Installation Rules
• UTP Cable Attenuation
• Installing Category Data Cables
• Parameters of EIA/TIA 568
• Separation from Sources of Interference
• Structured Cabling (568) Systems
• Standard Networking Configurations
• Telecommunication Outlet Specifications
• UTP Connecting Hardware