Standard Networking Configurations
| Standard Networking Configurations | |
|---|---|
| ATM 155 Mbps uses pairs 2 and 4 | (pins 1-2, 7-8) |
| Ethernet 10Base-T uses pairs 2 and 3 | (pins 1-2, 3-6) |
| Ethernet 100Base-T4 uses pairs 2 and 3 (4T+) | (pins1-2, 3-6) |
| Ethernet 100 Base-T8 uses pairs 1,2,3 and 4 | (pins 4-5, 1-2, 3-6, 7-8) |
| Token-Ring uses pairs 1 and 3 | (pins 4-5, 3-6) |
| TP-PMD uses pairs 2 and 4 | (pins 1-2, 7-8) |
| 100VG-AnyLAN uses pairs 1,2,3, and 4 | (pins 4-5, 1-2, 3-6, 7-8) |
Guides
- Lamp Guide: General Information
- Lamp Guide: Fluorescent
- Lamp Guide: HID
- Lamp Guide: Incandescent
- Line Noise
- Power Surges and Spikes
- Brownouts
- Blackouts
- Heat Dissipation in Electrical Enclosures
- Hazardous Location Basics
- Basic Proximity Sensor Operations
- Occupancy Sensor Design Guide
- Occupancy Sensor Application Guide
- Color Application for HID Lamps
- Cutler-Hammer Heater Coil
- General Electric Heater Coil
-
Electrical Tables
- Allowable Ampacities Insulated Conductors
- Conduit Fill Table
- NEMA Straight Blade Configs
- NEMA Locking Blade Configs
- Common Conversion Factors
- Derate 3 Conductors in a Raceway
- Direct Current Motor Full Load Current
- Approximate Full Load Amperes
- Full Load Current: Three Phase AC Motors
- Full-Load Current: Single Phase AC Motors
- Specific Resistance
- Temperature Conversion Table
- UL Fuse Classification Chart
- Buck Boost Transformer Full Load Amps
-
Calculations
- Ohm's Law
- Electrical Formulas
- Full Load Formula
-
Datacomm Tables
- Attenuation for Coaxial and UTP Cables
- Backbone Runs: UTP Cable
- Basic/Channel Link Attenuation
- Basic/Channel Link Next Loss
- Cable Administration
- Category Cables
- Circuit Protection
- Common Ethernet Systems
- Common Types of Cabling
- Computer Circuits
- Copper Wire Limitations
- Digital Patch Cable (DPC) Coding
- 10Base-T Crossover Patch Cord
- 10Base-T Straight Thru Patch Cord
- General Cable Installation Rules
- UTP Cable Attenuation
- Installing Category Data Cables
- Parameters of EIA/TIA 568
- Separation from Sources of Interference
- Structured Cabling (568) Systems
- Standard Networking Configurations
- Telecommunication Outlet Specifications
- UTP Connecting Hardware
